Additional Safety Information; Lithium Battery Notice - IBM ThinkCentre 8131 User Manual

v Always store CD/DVD discs out of direct sunlight and away from direct heat
v Remove CD/DVD discs from the computer when not in use
v Do not bend or flex CD/DVD discs, or force them into the computer or their
v Check CD/DVD discs for cracks before each use. Do not use cracked or

Additional safety information

DANGER
Electrical current from power, telephone, and communication cables is
hazardous.
To avoid a shock hazard:
v Do not connect or disconnect any cables or perform installation, maintenance,
v Connect all power cords to a properly wired and grounded electrical outlet.
v Connect to properly wired outlets any equipment that will be attached to this
v When possible, use one hand only to connect or disconnect signal cables.
v Never turn on any equipment when there is evidence of fire, water, or
v Disconnect the attached power cords, telecommunications systems, networks,
v Connect and disconnect cables as described in the following table when

Lithium battery notice

CAUTION:
Danger of explosion if battery is incorrectly replaced.
When replacing the battery, use only IBM Part Number 33F8354 or an equivalent
type battery recommended by the manufacturer. The battery contains lithium and
can explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
sources
packaging
damaged discs
or reconfiguration of this product during an electrical storm.
product.
structural damage.
and modems before you open the device covers, unless instructed otherwise
in the installation and configuration procedures.
installing, moving, or opening covers on this product or attached devices.
To connect:
1. Turn everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
To disconnect:
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
Important safety information
ix