Appendix; Trouble Shooting Guide - SONIQ DVR150 Operation Manual

TROUBLE SHOOTING GUIDE

When having problems with this unit, please check the chart below for a possible solution before
requesting servicing.
SYMPTOM
1. The power plug not connected
No power 2. Power plug and socket not contact tightly
3. The power socket not switched on
1.Signals not properly connected
No sound
2.Discs wrapped or dirty
3.The unit in the mute status
1.Signals not properly connected
2. The TV set not properly adjusted
No picture
3.This video output system of this unit not
1.TV system not right
2.TV set's color saturation not properly
No color
3.Video output setting not right
1.No disc in the drive
2.Disc not properly placed
No disc
3.Condensation on the laser head
reading 4.Not in the playback mode
5.Wrong disc format
6.Disc dirty
1.Remote control not pointing to the sensor window
2.Remote control more than 8 meters away from
Remote control
failure
3.Remote control butteries' voltage become low
4.Obstacles between remote control and the unit
1.Disc information not well stored
Instantaneous
2.Wrong buttons pressed
function failure
3.Extermal static leakage into the cover
Picture rolling 1.TV system not suitable for the disc
1.The system not properly connected
External signals 2.No disc or the disc not recordable
3.The disc finalized
record failure
4.No space left in the disc
1.The input source is not prepared well
No monitoring
2.The video output system not adequate
signal 3.The actual input source and selected input
1.The disc not meet the requirements
2.Wrong time settings (system clock or
Time recording
failure 3.The source not work property when
4.Powered off
Recording 1.No space left in the recording disc
2.Too bad quality of the recording disc
abortion

APPENDIX

CAUSE
matching the TV scanning manner
adjusted
the TV set
source not correspond
recording time)
recording
1.Connect the power plug into the wall outlet securely
2.Plug again or change another socket
3.Switch on the power socket
1.Connect signals securely
2.Clean and process the discs
3.Press the [MUTE] button again
1. Connect signals securely
2. Reset your TV sets AV/TV status
3. Press the [I/P] button
1.Press the [I/P] button to reset the system
2.Re-adjust the TV set's saturation
3.Re-adjust video output settings
1.Load a disc
2.Reload the disc with the playback side facing down
3.Turn on the power for about 1 hour without a disc
before playing
4.Press the [PLAY] button
5.Load the discs
6.Carefully clean the disc with soft cloth outwards from
the center
1.Hold the remote control in proper position
2.Use the remote control nearer to the TV set
3.Replace the batteries
4.Remote obstacles
1.Wait for 5-10 seconds and this unit will restore
normal playback.
2.Press the right button
3.Restart playing after unplugging this unit for 1-2 minutes
1.Adjust the TV system
1.Connect the system properly
2.Please a recordable disc
3.Replace the disc
4.Replace the recordable disc
1.Reset the signal sourcee
2.Switch video output system
3.Select proper input source
1.Reload new DVD R,DVD RW disc
2.Reset time recording settings
3.Ensure normal working of the source when recording
4.Switch the unit to the standby mode
1.Reload a blank disc
2.Use high quality recording disc
47
REMEDY
± ±