Manual Recording; Summarization; Operation Steps - SONIQ DVR150 Operation Manual

Summarization

This function can make this unit record automatically according to the preset requirements when the preset
time is coming. And it will resume the original mode after finishing the recording. To carry out this function.
You should set down a record schedule first and then finish the configuring of the system according to the
requirements on the schedule.
Programming a Recording Steps
1
Press the [TIMER] button to display the record schedule menu shown as the following figure.
This menu is composed of 8 notes, each of which stands for one record scheduler.
Highlighting any non-empty note by cursor buttons, and the pressing [ADD/CLEAR] button,
can delete it.
2
Highlight a note in "Record scheduler", and press [ENTER] button, then the TV screen displays the
following dialogue window.
Performing the relative setting in this item
Editor window can make a record scheduler.
3
Setting the input source:
Highlight "Source" item by sursor[
down list, then select the right item from the list. At last, press [ENTER] button to confirm.
Please refer to "System Setup - Record
Settings - Default Input Signal Sources
Selection" for the values of the "Source"
item.
For example, if you want to record the
P003 TV program, you may set the value of
the Source item to P003.

MANUAL RECORDING

Record scheduler
. Source
No
1
2
3
4
5
6
], [ ] buttons, and press [ENTER] button to display the drop
Quality Date Start End
Item Editor
Source Front CVBS
Quality
SP
Mode Once
Date 01 / 01 / 00
Start
01 : 48
End
02 : 18
PDC OFF
Cancel
OK
The item Editor window
Item Editor
Source
Front CVBS
Quality Front CVBS
Front S-VIDEO
Mode
Rear CVBS
Date 01 / 01 / 00
Rear S-VIDEO
Start 01 : 48
End 02 : 18
OFF
PDC
Cancel
OK
19
PDC