Progressive/Interlace Setup; Video Output Format Setup - SONIQ DVR150 Operation Manual

MENU INDEX FOR INITIAL SETUP
Screen Saver Setup (CONTINUED)
3
Move the cursor up and down to select "ON" or "OFF" by [ ], [ ] buttons.
4
Press [ENTER] button to turn on or off the screen saver function.
Pressing any button can exit the screen saver mode after the screen saver picture appears.
Progressive / Interlace Setup
1
In the general setup menu, use [ ], [ ] buttons to select "Progressive / Interlace"
item and press [ENTER] button, then a list will appear.
2
Select "Progressive" or "interlace".
3
Press [ENTER] button to fulfill the
Progressive / Interlace switch.
4
Pressing the [I/P] button can proceed
the Progressive / Interlace switch as well.
The value of this setting must Correspond with
the scanning mode of the TV, otherwise the TV
screen will display nothing.
If nothing is shown on the TV screen, you
may try to press the [I/P] button for 5 seconds.
I/P key is only valid in YUV.

Video Output Format Setup

This unit has two video output system: PAL and NTSC. You can select one of them according to
your TV set specs.
1
Highlight "Video output format" in the general
setup menu and press [ENTER] button. A pop-up
menu will appear.
2
Select the proper option according to factual requirements.
3
Press [ENTER] button, then the system will switch the
output format to what you select right now.
You can also switch the TV output format by pressing the
[N/P] button.
Changing the output format may cause no picture on the TV screen. If this happens, you can press
[N/P] button to restore the output format.
SYSTEM SETUP - GENERAL
Screen saver
progressive/Interace
Country
Scart output
Video output format
Restore factory settings
SYSTEM SETUP - GENERAL
Screen saver
progressive/Interace
Country
Scart output
Video output format
Restore factory settings
35
ON
Interlace
Progressive
Interlace
YUV
PAL
OK
ON
Interlace
Germany
YUV
PAL
NTSC
PAL