What To Do In The Event Of An Unexpected Standstill; Hand Wheel Operation (Metal Hood); Evacuation (Metal Hood) - Lippe Lift T80 Operation Manual

4.7 What to do in the event of an unexpected standstill, e.g. due to a power
failure?
We recommend that a working mobile telephone be carried in order to alert the
rescue services.
4.7.1 Hand wheel operation / by technical personnel only (version with metal hood)
The T80 platform lift can also be operated manually. Manual operation must be
performed by technical personnel! The procedure is as follows:
a) Press the EMERGENCY STOP button (p.7/item 3) on the platform.
b) Loosen the screws of the hood. Tool for is supplied in the envelope.
c) The platform hood (p.7/item 5) is to be raised and secured against falling down
by means of the vertically adjustable lever (see sketch overleaf).
d) The brake venting lever is to be pressed upward or downward whilst at the
same time turning the hand wheel on the end of the motor shaft (see sketch
overleaf).
In doing so, the direction of travel should always be towards the lower station
(less energy expenditure when turning the hand wheel). The respective direction
of rotation is indicated directly on the hand wheel.
Note: If the cause of the standstill is not clear, it should be assumed that the safety
arrester has been triggered and that its safety switch has led to the lift switching
off. The safety arrester may only be reset by technical personnel. In this case,
proceeded as described above, but first turn the hand wheel in the UP direction
(until the lift has moved approx. 5cm along the running rail), after which the hand
wheel can be turned in the DOWN direction.
4.7.2 Evacuation / by technical personnel only (version with metal hood)
Proceed as follows in order to help the operator out of the platform lift:
- see paragraph 4.7.1, but only as far as b)
- On the uphill side there is a red-marked Bowden cable, which is to be pulled
towards the operator. The uphill side safety barrier can then be raised manually
at the same time.
- The operator can now be helped out at the uphill side.
The platform must be folded up by hand so that the platform lift does not block
the staircase (see 4.5.2).
Operating instructions T80PL 2010 15/21 (01/2010)