SOYO SY-6BA+100 User Manual page 102

The ATA 66 Driver installation
2. Checking the Installation
If you want to check if the HPT370 host adapter and its device driver are
correctly installed, you can:
(1.) Open My Computer
(2.) Open Control Panel
(3.) Double click icon SCSI Adapters
(4.) You should see the item HPT370 Ultra DMA Controller (started)
listed
3. Partitioning Your Hard Disk
If the hard disk drive attached to the HPT370 host adapter has not been
partitioned and formatted yet, you need to partition it first. To partition the
hard disk drive attached to the HPT370 host adapter, follow the following
steps:
(1.) Click the Startup button
(2.) Go to Administrative Tools (Common)
(3.) Run Disk Administrator
(4.) Select disk number you would like to partition
(5.) Select the menu Partition
(6.) Decide the partition size create partition of the size
(7.) Exit Disk Administrator
(8.) Select the new created partition (logical disk drive) and format it
4. Troubleshooting
The boot manager for Windows NT contains recovery logic to allow you
to return to the last known good configuration. If you have changed your
host adapter configuration and Windows NT no longer boots, follow these
steps to recover:
1. Undo any hardware changes you have made to the computer
since it was last operational.
2. Reboot the computer. Watch the display carefully during booting
up. If the following message appears, press the Spacebar and
follow the instructions on the display screen to continue booting
98
SY-6BA+100