Lan Setting - SMART Board SB480iv2 Configuration And User's Manual

APPENDIX A
REMOTELY MANAGING YOUR SYSTEM THROUGH A NETWORK INTERFACE

LAN Setting

This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP isn't used. You can also change the projector
name, location and contact information.
Submenu setting
Model name
Projector name
Location
Contact
DHCP
IP Address
Subnet Mask
Gateway
DNS
Crestron® Control System Device
IP Address
Device ID
Port
47 smarttech.com/kb/170782
Description
Displays the projector's model.
Type a name for the projector. Click Save.
Type a location for the projector. Click Save.
Type contact information. Click Save.
Determines if the projector's IP address and other network settings
are dynamically assigned by a DHCP server or are manually set.
DHCP allows the network's DHCP server to assign a dynamic
l
IP address to the projector.
Manual allows you to manually set the projector's IP address
l
and other network settings.
Displays or allows you to set the projector's IP address in values
between 0.0.0.0 and 255.255.255.255.
Displays or allows you to set the projector's subnet mask number in
values between 0.0.0.0 and 255.255.255.255.
Displays or allows you to set the projector's default network
gateway in values between 0.0.0.0 and 255.255.255.255.
Displays or allows you to set the projector's IP address for your
network's primary domain name server in values between 0.0.0.0
and 255.255.255.255.
Type the IP address for the Crestron RoomView® Express
management software.
Type the Device ID for the Crestron RoomView Express
management software.
Configure the Port for the Crestron RoomView Express
management software.