Connector Board - HP Chromebook 11-2100 Maintenance And Service Manual

NOTE: If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve
must be installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.

Connector board

NOTE: The connector board spare part kit includes the cable.
Description
For use only on computer models equipped with WWAN capability (includes SD Card Reader slot and
SIM slot)
For use only on computer models not equipped with WWAN capability (includes SD Card Reader slot)
Before removing the connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the keyboard/top cover (see
5. Remove the WWAN module (see
Remove the connector board:
1. Release the ZIF connector (1) to which the connector board cable is attached, and then disconnect the
connector board cable from the system board.
2. Remove the two Philllips PM1.9×4.2 screws (2) that secure the connector board to the base enclosure.
Keyboard/top cover on page
WWAN module on page 34).
Spare part number
785884-001
783087-001
25).
Component replacement procedures 35