Abnormal Hob Operation - Mastercook 2MIE-4GLS X Instructions For Use And Maintenance Manual

ATTENTION !
Burners, igniters and thermocouple ends should be cleaned after each flooding.
Blooms and contaminations must be removed regularly.

To clean the burner, remove its cap and crown (Fig. 12), soak them in warm water with detergent
and wash each part separately.

Use a sponge or a brush to wash burner parts and a steel wire to unblock flame openings. After
cleaning, make sure that the flame openings are not clogged.

Cleaned burner parts should be thoroughly dried because if they are wet the gas will not burn or will
burn improperly. After drying, re-install the burner elements in the order reverse to that used during
their removal and do not damage igniters and thermocouple ends.Cleaning the electric plate

5 ABNORMAL HOB OPERATION

Attention !
Before troubleshooting disconnect the hob plug from the electric socket.

Failures can occur during the hob operation. Some minor faults may be remedied by the user
according to directions in Table 3.

During the warranty period, all repairs except those specified below should be carried out by an
authorised service workshop.

After the warranty period, a user should have the appliance inspected by a service shop regularly.
Symptoms
Igniters fail to ignite
or not always ignite
the gas.
Burner will not
ignite
Clogged flame
openings in the
burner.
Clogged (flooded)
nozzle
The igniter Open circuit in
will not ignite electric system
gas (no
Contaminated
spark)
burners or igniters
ABNORMAL HOB OPERATION
Causes
 Check to make sure the hob is connected to the electrical
mains.
 Clean and dry the igniters and burner components.
 Check to make sure the burner caps and heads are placed
correctly.
 Press on the burner cap and rub it against the head by
turning right and left .
 Rub the igniters electrode with the use of hard brush or
smooth file.
 Close all control knobs
 Close shut-off cock
 Ventilate the room
 Remove and clean burner parts making sure that flame
openings are not clogged
 Install all burner parts properly and try to ignite the burner
again
 Remove all burner parts
 Clean and dry the hob recess of the relevant nozzle
 Clean the nozzle and unblock it with thin copper wire if
necessary (never use the steel wire or enlarge the opening)
 Check the fuse in a house electric system and replace if
burnt out
 Clean and thoroughly dry burners and igniters
Troubleshooting
12
Table 3
UK