Nozzle Replacement; Adjusting Control Knobs - Mastercook 2MIE-4GLS X Instructions For Use And Maintenance Manual

ATTENTION !
1. Checking the leakage with an open flame (e.g. with a match or a candle) is
unacceptable. It may lead to an explosion !
2. Check condition of the hose and connection tightness regularly, according to the
valid regulations.

2.4 NOZZLE REPLACEMENT

ATTENTION !
Before nozzle replacement and adjustments, disconnect the hob from the mains.
Nozzle diameters for particular gas type are shown in Table 2.
2H (G 20 20 mbar)
2H (G 20 13 mbar)
G 30/31 29/37 mbar
The hob is adjusted to the type of gas and pressure stated on the appliance's rating plate.
In the event of a change of the type of gas replace the nozzles and adjust the taps.
Before beginning these activities you must:
shut down the cock shutting off the gas supply system or cylinder from the hob,-shut
–
down all the taps in the hob,
disconnect the hob from the mains.
–
Then:
remove the burners' lids and rings,
–
remove the nozzles and replace them with new ones in accordance with table2,
–
put burners' rings and lids back,-
–
adjust the taps and check the connections for soundness

2.5 ADJUSTING CONTROL KNOBS

ADJUSTING THE TAPS
The adjustment of a gas tap consists in setting the burner flame in the simmering position. To
adjust the taps remove all the knobs and control panel Then:
– open the gas flow with a knob and light the adjusted burner,
UK
INSTALLATION
AUX burner
X072
084
050
Fig. 12
7
SR burner
Z097
110
065
Table 2
R burner
Y118
145
085