Mastercook 2MIE-4GLS X Instructions For Use And Maintenance Manual page 20


After unpacking, make sure that the hob has no visible damage and the power cord is in good
condition. If there is a damage, please contact our Customer Service.

This hob may be installed on a worktop that is at least 30mm thick (Fig. 5). The worktop must be
heat-resistant.

The wall next to the rear side of the hob should be made of incombustible material.

A minimum distance of 100mm must be maintained between the side edges of the hob and any
adjacent furniture.

To reduce negative impact of draught on burner operation, do not install this hob on the window-door
line.

There should be a free space left over the hob for discharging fumes. The best solution is to install a
cooker hood which will absorb and discharge these fumes. The minimum distance between the hob
and cooker hood is 650mm.

There must not be any cabinet fitted right above the hob.

In case of mounting a horizontal partition "A" under the hob, leave the distance at least 150mm
between the hob and the partition (Fig. 6).
1. Make the 490 x 560 [mm] rectangular cut-out in the worktop. The dimensions of the cut-out can be
found in Fig. 7.
2. The hob is equipped with a seal with tape-protected adhesive surface. Remove the tape from the
seal.
3. Turn the hob upside down and stick the seal around the internal edge (Fig. 8).
UK
Fig. 5
Fig. 7
INSTALLATION
5
Fig. 6
seal
Fig. 8