Flame Adjusting; Igniting Burners - Mastercook 2MIE-4GLS X Instructions For Use And Maintenance Manual


If the hob is equipped with a flame failure protection after igniting the burner keep the control
knob fully pushed for a while to activate the protection.

Do not overload the grates.

Never touch hot burners, graters, pots and pans.

To obtain proper and economical burners operation make sure that:

flame height is adequate,

pots and pans are properly selected.
thermocouple
igniter

3.1.1 FLAME ADJUSTING


Gas flow in individual burners is opened and closed using control knobs.

Before igniting the burner make sure that the corresponding control knob is to be operated.

Corresponding burners and control knobs are shown in Fig. 15.

Flame height depends on the control knob position (Fig. 16). Adjust the flame only between
.

Flame should not spread beyond the bottom of the vessel but spread on 2/3 of the vessel's bottom.
This will ensure gas efficiency and the flame will not singe pots and pans.

When the control knob is in position
starts boiling and then turn down the flame to small
Fig. 15

3.1.2 IGNITING BURNERS

2MIE-4GLS X; 2MIE-4GLS B

push the knob of a burner until it stops, then turn it anticlockwise and push down until the burner
ignites, do not release the knob for another 5 seconds in order to activate flame failure
protection

if the flame goes out, repeat these steps keeping the knob pushed for 5 seconds longer
adjust to the desired flame height between


UK
OPERATION
Fig. 14
the flame is high. High flame should be used until a liquid
(economical) for further cooking.
0 – burner turned off;
(economical)
and
9
Burner with flame failure
protection
– high flame; – small flame
Fig. 16
and