Connecting The Hob To The Natural Gas Supply; Connecting The Hob To The Liquid Gas Bottle - Mastercook 2MIE-4GLS X Instructions For Use And Maintenance Manual

4. Place the hob in the middle of the cut-out and push it so that the seal adheres tight to the worktop.
5. Fix the hob with the four brackets which are included together with other connecting parts (Fig. 9 and
10).
6. After installing the hob, the horizontal partition "A" may be placed under the worktop which will
protect the user against accidental touching of a hot hob from the bottom.
rear brackets
front brackets

2.2 CONNECTING THE HOB TO THE NATURAL GAS SUPPLY

Attention !
1. The hob must be connected to the gas system according to relevant regulations
and by an authorised gas fitter.
2. Before installation, make sure that the shut-off cock is closed.

This hob is designed for gas and pressure indicated on the rating plate. The hob is equipped with an
elbow and seal (Fig. 11).

Connection to the internal gas system should be either rigid or with a flexible metal pipe.

Gas supply is ended with a shut-off cock. The shut-off cock should be easily accessible after
installing the hob in the worktop.

2.3 CONNECTING THE HOB TO THE LIQUID GAS BOTTLE


The hob may be converted for use with liquid gas. For this purpose nozzles in burners have to be
replaced and knobs have to be adjusted.

If this hob is intended for use with gas bottles, it should not be installed in a cellar or any other
compartment with a floor below ground level as the liquid gas is heavier than air and accumulates at
the floor level.

When connecting the hob to the gas bottle, use a certified rubber hose.

Each time the gas bottle is connected, check the tightness of the valve on the gas bottle and the
connection and operation of the reducer.
INSTALLATION
Fig. 9
worktop
bracket
Fig. 11
6
gas hob
Fig. 10
UK