Volvo Penta MS2 Workshop Manual page 50

Repair - MS2 reverse gear and upper gear housing, sailboat drive
112. Measure the distance between the gear wheel
and the bearing.
Also refer to item 106.
113. Put on, from the left, the measured spacer wash-
er, three small domed washers, a large domed washer
and the lock washer.
48
114. Press down the large washer so far that the re-
taining ring halves can be put in the groove.
Use tool no. 884725.
115. Put the plain bearing (1) on the shaft and install
the slipping clutch.
884725
1