Table of Contents
Advertisement
22. Pull up the sliding sleeve with a turning motion.
23. Reverse gear MS2
Press the outer bearing race out, using the vertical
shaft. Keep hold of the vertical shaft, to prevent it
from falling and being damaged. Save any shims be-
neath the bearing race.
NOTE! On the sailboat drive, the shaft is loose since
there are no bearings.
24. Put the vertical shaft in a press and press the
large washer with tool no. 884725, to release the re-
tention ring halves. Remove the halves.
Repair - MS2 reverse gear and upper gear housing, sailboat drive
25. Remove the lock washer (1), the large domed
washer (2), the three smaller domed washers (3), any
spacer washers (4) and the needle roller bearing (5).
884725
26. Press the gear wheel out. Use tool no. 884733 in
combination with standard shaft 9991801.
2
1
3
9991801
5
4
884733
25
Hide quick links:
Advertisement
Table of Contents
