Volvo Penta MS2 Workshop Manual page 29

31. Drive or press the input shaft out of the bearing
housing. Use a plastic-faced mallet or similar, to avoid
damaging the end of the shaft and the splines.
884143
32. If the roller bearings are damaged, they must be
changed. Remove the large outer bearing race from
the bearing housing, using tool no. 884726 and shaft
884143.
Repair - MS2 reverse gear and upper gear housing, sailboat drive
33. Drive out the small outer bearing race, using tool
884728 and shaft 9991801.
NOTE! Be careful to offer up the tool against the bear-
ing race.
884726
34. Remove the roller bearing from the input shaft, us-
ing a knife-type extractor. Then remove the washer.
Clean the components and check for wear, replace
worn and damaged components.
9991801
884728
27