Volvo Penta MS2 Workshop Manual page 38

Repair - MS2 reverse gear and upper gear housing, sailboat drive
66. Press a roller bearing onto the output shaft. Use
tool no. 884729.
67. Install a new ferrule (1).
NOTE! Always use a new ferrule when the output
shaft has been removed from the housing.
36
884729
68. Place the drive shaft in the bearing housing and
press the other roller bearing on, using tool no.
884729.
NOTE! Do not press the bearing until it bottoms.
Some clearance must be left. When the nut is torqued
to the correct value, the bearing housing is pre-loaded
and the clearance disappears.
1
69. Apply sealant, Volvo Penta part. no. 840879-1 on
the mating face of the seal ring against the bearing
housing.
Install the seal ring in the bearing housing. Press the
outer diameter of the seal with a mandrel.
Wipe some grease, Volvo Penta part no. 828250-1 on
the ring.
884729