Worx WG251.5 Owner's Manual page 12

to be pressed for the hedge trimmer to start.
Depress and hold the front switch lever (5) and
press the rear switch lever (6) (See h).
to Stop your hedge trimmer
Move hedge trimmer away from cutting area
before stopping.
To stop, release one of the switch levers (See
I).
warning: if any parts are missing,
damaged or broken, do not operate
your hedge trimmer until all damaged
parts have been replaced or repaired.
Failure to do so could result in serious
personal injury. do not uSe without
handle and guard
9. how to uSe your hedge trimmer
Note that the switch lever can be activated
on three sides, giving you many choices for
a comfortable grip. Before cutting an area,
inspect it first and remove any foreign objects
that could become thrown or entangled in
the blades. Always hold the trimmer with
both hands and with the blade away from you
before turning it on.
12 12
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade. (See J & K)
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
trimmer. Release the two switch levels (5 & 6)
before attempting to clear jammed debris from
the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick
for the cutting blade.
top cutting
Use a wide sweeping motion (See J). A slight
downward tilt of the cutting blades in the
direction of motion gives the best cutting
results.
Side cutting
When trimming the sides of the hedge,
begin at the bottom and cut upwards (See
K), tapering the hedge inward at the top. This
shape will expose more of the hedge, resulting
Cordless li-ion hedge trimmer
in a more uniformed growth.
10. cleaning
ReMoVe The BATTeRY PACK. Use a soft brush
to remove debris from all air intakes and
cutting blade.
Wipe the surface with a dry cloth.
warning: Never use water for
cleaning your trimmer. Do not clean with
chemicals, including petrol, or solvents as this
may damage your trimmer.
luBricating the cutting Blade
For easier operation and longer life, lubricate
the cutting blades before and after each use.
Before lubricating, make sure the battery is
removed from the trimmer. Apply oil between
the two blades periodically (See L).
at the end oF the cutting SeaSon
Clean your trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the trimmer for any worn or
damaged parts.
11. Storing your hedge trimmer
1) aSSemBly the wall mount
Bracket (See Fig m)
Attach the wall-mount bracket to the wall with
the screws provided.
Tighten all the screws securely. Carefully check
the bracket after mounting to make sure that
no movement can occur during use.
warning: Always make sure your
wall-mount bracket is securely mounted
to the wall. Failure to do so could result in an
accident, resulting in possible serious personal
injury.
2) Storing your hedge trimmer
Insert the hedge trimmer into blade sheath,
and then store the hedge trimmer into the wall
mount bracket as illustrated (See Fig N)
Store in a dry place where your trimmer can
be protected from damage.
EN