Install Base Grille; Complete Installation - Jenn-Air JS42NXFXDW Installation Manual

2. Insert the circular post on the back of the handle spacers into
the holes in the door panels.
A B
A. Plastic handle spacer
B. Straight handle mounting posts
C. Curved handle mounting posts
D. Circular post
3. Depending on the compartment, rotate the plastic spacer so
that the curved handle mounting posts are either at the top or
bottom. See following chart.
Freezer
Left-Hand Door
Curved
Mounting Post
Setscrews
4. Slide the screw into the handle mounting stud. Insert the
screw assembly into the center hole of the plastic spacer and
fasten it to the door panel.
5. Install the handles to the handle mounting studs so that the
setscrews are on the designated side and tighten the
setscrews.

Install Base Grille

There are two pieces to the base grille to allow for a custom fit: the
base grille itself and the skirt. The skirt can be added to the base
grille in order to extend it all the way to the floor.
1. To see whether the skirt is needed, place the base grille into
position. Do not attach the base grille to the refrigerator.
Measure the distance between the bottom of the base grille
and the floor. The gap must be a minimum of ¹⁄₂" (1.27 cm) in
order to add the skirt.
NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skip
steps 3 and 4 of the instructions, and install the base grille
only.
2. Remove the film from the base grille.
3. Snap the skirt onto the base grille.
A. Base grille
B. Skirt
C D
B
Refrigerator
Right-Hand Door
Bottom Top
Right Left
A
B
4. Trim the skirt by scoring the proper "V" groove with a utility
knife. Break the skirt at the score line.
C
5. Using the two screws, attach the base grille assembly to the
refrigerator as shown.
NOTE: Drive in the right side screw first.
1. Turn the water supply line valve to the "Open" position.
2. Turn the refrigerator switch to the ON position. See "Power
On/Off Switch" in the Use & Care Guide for instructions. Wait
a few minutes. Check the water line connections for leaks.
3. Remove all boxes, parts packages and packing materials from
the interior of the refrigerator. See the "Cleaning" section in
the Use & Care Guide for instructions. Remove the film and
cardboard from the grille and doors or door frame, depending
on your model.
4. Install the shelves and bins in the refrigerator and freezer
compartments.
5. The controls are preset at the factory to the midpoint setting.
Check that the compressor is operating properly and that all
the lights are working.
6. Flush the water system before use. See "Water System
Preparation."
To get the most efficient use from your new built-in refrigerator,
read the Use & Care Guide. Keep Installation Instructions and Use
& Care Guide near the built-in refrigerator for easy reference.
A. "V" groove
A
A. Screws (2)

Complete Installation

23