Install Handles - Jenn-Air JS42NXFXDW Installation Manual

3. Using a ⁵⁄₃₂" Allen wrench, tighten the door stop pin.
A. Door stop pin hole
Complete Installation
1. Use the installation block to measure the gaps between the
panels and adjacent cabinets.
Custom wood overlay panels may be made with a ³⁄₈"
(0.95 cm) or ¹⁄₈" (0.32 cm) gap between the panel and
cabinets and a ¹⁄₈" (0.32 cm) gap between the freezer and
refrigerator door(s) and the door(s) and top grille.
All purchased panel kits require a ³⁄₈" (0.95 cm) gap
between the panel and the cabinets and a ¹⁄₈" (0.32 cm)
gap between the freezer and refrigerator door(s), and the
door(s) and top grille.
A
B
A. Adjacent cabinet
B. Installation block
C. Panel on door
2. Adjust the panel to achieve the required spacing, or to align.
IMPORTANT: If adjustments are needed, adjust the panel not
the door. Adjust left to right in the mounting bracket before
using the pins to adjust the panel up and down or at an angle.
Slide the panel from side to side in the keyhole slot.
22
Use an Allen wrench to raise or lower the adjustment pins
which allows the door panel to swivel.
A
3. Predrill a ¹⁄₈" deep pilot hole the door panel through the open
holes in both the bottom and top hinges.
4. Using slotted hex head screws (provided with refrigerator),
attach the top and bottom hinges to the door panels. Fully
tighten all door panel screws.
5. Using slotted hex head screws (provided with refrigerator) for
each side, attach the door panels to the hinge-side door trims.
C
6. Using Phillips head flat screws (provided with refrigerator),
install the handle side door trim.
7. Completely tighten the screws attaching the mounting
brackets, located at the bottom of the doors, to the overlay
panels.
8. Reinstall the top door trim and hinge cover.
9. Snap the adjustment pin cover (provided with refrigerator) into
place.
IMPORTANT: Install the handles after the door panels have been
installed. Follow the instructions specific to your door panel
design.
Tools Needed: ³⁄₃₂" Allen wrench
Door Panels - Custom Wood, Stainless Steel and
Oiled Bronze Designs
1. Locate the holes in the door panels where the handle
mounting studs are to be installed.
2. Fasten the handle mounting studs to the door panels.
3. Install the handles to the handle mounting studs and tighten
the setscrews.
Door Panels - Floating Glass Design
IMPORTANT: To align the handle correctly on the door, the plastic
handle spacer and the setscrews on the door handle must be in
the positions designated in the chart.
1. Locate the holes in the door panels where the handle
mounting studs are to be installed.
C
A. Door panel C. Adjustment pins
B. Mounting bracket
A
C
A. Top hinge C. Holes for screws
B. Mounting bracket D. Adjustment pins

Install Handles

(Panel Kit Models Only)
A
B
B
D