Jenn-Air JS42NXFXDW Installation Manual page 20

3. Using the installation block as a guide for depth, screw the
door studs (provided with refrigerator) into the predrilled door
panel (two door studs per door).
A. Door stud
B. Installation block
4. For the mounting bracket, insert the hex head pointed screws
(provided with refrigerator) into the wood at the top of the door
panels where they were predrilled.
NOTES:
It is critical to use the ⁵⁄₈" screw, the longest length
provided, to attach the bracket to the top of the door
panel. These hex head pointed screws are used only to
attach this mounting bracket.
Panel Kits - Find the holes to attach the hex head pointed
screws by locating the slots in the door panel, not the
U-shaped holes.
5. Attach a mounting bracket to the top edge of each door panel
by placing the large end of the keyhole slot over the screws
and sliding the bracket so that the screws are centered in the
slots.
NOTE: Start with the screws in the center of the slots as
shown, then move the door panel, as necessary, to align.
A
A. Door panel
Top Grille Panel
1. Using the slotted hex head screws (provided with refrigerator),
attach a mounting bracket to each side of the top grille panel.
IMPORTANT: See the Parts Provided insert sheet to select
the brackets designated for your installation.
Use the Integrated Grille brackets for an Integrated
Installation with a full height grille.
20
A
B
B
B. Mounting bracket
Use the Standard Grille brackets for a Standard
Installation with a closed or open soffit.
A. Top grille brackets
B. Grille trim piece
2. Using round head screws (provided with refrigerator), attach
the grille trim piece to the bottom of the grill panel.
NOTE: The grille trim is pre installed on the panel kits.
Remove Trim Pieces
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer doors.
3. Remove the hinge cover pieces from the top and bottom of
the door to expose the holes in the hinges.
NOTE: It is not necessary to remove the hinge side trims as
they will not interfere with the installation.
4. Remove the handle side trims. See the following graphic.
A
B
A. Hinge cover pieces
B. Handle-side door trim
A
B
A
B
A