Wireless Setup - D-Link DCS-7000L User Manual

Section 4: Configuration
This section allows you to set up and configure the wireless settings on your camera.
After making any changes, click the Save Settings button to save your changes.
Site Survey: Click the Rescan button to scan for available wireless networks. After
scanning, you can use the drop-down box to select an available
wireless network. The related information (SSID, Wireless Mode,
Channel, Authentication, Encryption) will be automatically filled
in for you.
SSID: Enter the SSID of the wireless access point you wish to use.
Wireless Mode: Use the drop-down box to select the mode of the
wireless network you wish to connect to. Infrastructure is
normally used to connect to an access point or router. Ad-Hoc is
usually used to connect directly to another computer.
Channel: If you are using Ad Hoc mode, select the channel of the wireless
network you wish to connect to, or select Auto.
Authentication: Select the authentication you use on your wireless network -
Open, Shared, WPA-PSK, or WPA2-PSK.
Encryption: If you use WPA-PSK or WPA2-PSK authentication, you will need
to specify whether your wireless network uses TKIP or AES
encryption. If you use Open or Shared authentication, WEP
encryption should be the setting.
Key: If you use WEP, WPA-PSK, or WPA2-PSK authentication, enter the
Key (also known as password) used for your wireless network.
D-Link DCS-7000L User Manual

Wireless Setup

34