Fuel Hose - Mercury 75 HP Installation Manual

Fuel Hose

PORTABLE FUEL TANK
Select a suitable location in boat within engine fuel line length limitations and secure tank
in place.
PERMANENT FUEL TANK
These should be installed in accordance with industry and federal safety standards which
include recommendations applicable to grounding, anti-siphon protection, ventilation, etc.
FUEL HOSE SIZE
Minimum fuel line inside diameter (I.D.) is 5/16 in. (8mm), with separate fuel line/fuel tank
pickup for each engine.
FUEL HOSE CONNECTION
Fasten remote fuel hose to fitting with hose clamp.
Speedometer (Optional) Water Pick-up
This outboard is equipped with a speedometer water pick-up located in the leading edge
of the gear case. If this water pick-up is to be used, locate the hose coming out of the front
grommet. Cut off the end of the hose fitting and make the connection.
NOTE: If the speedometer water pick-up hose is not used, keep the hose routed out of the
rubber grommet.
a -
b -
c -
Prevent possible water leakage. Water pick up hose must be routed through grom-
met and outside of lower cowl at all times.
a
b
Fuel Hose
Hose Clamp – Secure Remote Fuel Hose
Speedometer Water Pick-up Hose for Optional Speedometer
75, 90 and 115 (4-STROKE) INSTALLATION MANUAL
CAUTION
c
Page 9 of 18