Tx-Sr505E/Tx-Sr575 Only); Connecting Components With Hdmi - Onkyo TX-SR505 Instruction Manual

Connecting Your Components —Continued
TX-SR505 North American Model/TX-SR505E/TX-SR575 Only

Connecting Components with HDMI

If you have an HDMI-compatible player, you can connect it to the AV receiver with an HDMI cable.
Step 1: Connect your HDMI-compatible TV to the AV receiver's HDMI OUT jack.
Step 2: Connect your HDMI-compatible player to the AV receiver's HDMI IN 1 or 2 jack.
Step 3: Connect your HDMI-compatible player to an analog and/or digital audio input on the AV
receiver.
✽ Audio and video signals received via the HDMI IN 1 and 2 jacks are output by the HDMI OUT jack as they
are (HDMI pass-through), so even if you only make the connections in steps 1 and 2, your TV will output
sound. However, if you want to listen through the speakers connected to the AV receiver, in addition to an
HDMI connection, you'll also need to make a separate analog or digital audio connection.
Step 4: Assign the HDMI IN.
Turn on the AV receiver, and then assign the HDMI IN (see page 38)
DVD player
✽
Step 3
IN 2
DIGITAL IN
ASSIGNABLE
COAX-
IAL
1
(DVD)
2
(CBL/SAT)
OPTICAL
1
(VCR/DVR)
CBL/SAT IN VCR/DVR IN
COMPONENT VIDEO
2
(CD)
L
R
REMOTE
CONTROL
CD
Connect one
or the other
Notes:
• Audio and video signals received via the HDMI IN jacks are output only by the HDMI OUT.
• Audio and video signals received via inputs other than the HDMI IN jacks are not output by the HDMI OUT.
• The HDMI video stream is compatible with DVI (Digital Visual Interface), so TVs and displays with a DVI input
can be connected by using an HDMI-to-DVI adapter cable. (Note that DVI connections only carry video, so you'll
need to make a separate connection for audio.) However, reliable operation with such an adapter is not guaranteed.
In addition, video signals from a PC are not supported.
• To watch an HDMI source that's connected via the AV receiver's HDMI jacks, the AV receiver must be turned on,
otherwise no HDMI signal will be output.
• The HDMI audio signal (sampling rate, bit length, etc.) may be restricted by the connected source component. If
the picture is poor or there's no sound from a component connected via HDMI, check its setup. Refer to the
connected component's instruction manual for details.
HDMI
HDMI
OUT IN
Step 2 Step 1
HDMI HDMI
ASSIGNABLE
IN 1
HDMI
IN 1 OUT ANTENNA
ASSIGNABLE
AM
FM 75
Y
CBL/SAT VCR/DVR DVD
V
C B/ P B
C P S
R/ R
DVD IN OUT
OUT
IN IN IN
IN OUT IN
IN OUT IN FRONT
L
L
R
R
TAPE CBL/SAT VCR/DVR
TV
Tip!
If you make the connection described in
step 3, to fully enjoy the AV receiver's lis-
SURROUND BACK
SPEAKERS
L
tening modes, turn down the volume on
your TV all the way so that its speakers
MONITOR
OUT
V
R
output no sound.
S
SURROUND CENTER SURR BACK
L
R
SUB
WOOFER
DVD
Sound off
27