Digital Input Signal Formats; Correcting Sound And Picture Sync; Receiver - Onkyo TX-SR505 Instruction Manual

Advanced Setup —Continued

Digital Input Signal Formats

The following table shows the display indicator for each
digital signal format.
Format Display
Dolby Digital
DTS
PCM
PCM
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can specify the signal format as either PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or reversing
a DTS CD, try the DTS setting.
STANDBY/ON
STANDBY
MULTI CH DVD VCR/DVR CBL/SAT AUX TAPE
PHONES
A SPEAKERS B TONE STEREO LISTENING MODE DISPLAY
DIGITAL INPUT
1
Press and hold the AV receiver's
[DIGITAL INPUT] button for about
DIGITAL INPUT
3 seconds.
2 While "Auto" is displayed (about
3 seconds), press the [DIGITAL
DIGITAL INPUT
INPUT] button repeatedly to
select: PCM, DTS, or Auto.
PCM: Only PCM format input sig-
nals will be heard. If the input
signal is not PCM, the PCM
indicator will flash and there
will be no sound.
DTS: Only DTS format input sig-
nals will be heard. If the input
signal is not DTS, the DTS
indicator will flash and there
will be no sound.
Auto (default): The format is
detected automatically. If no
digital input signal is present,
the corresponding analog input
is used instead.
MASTER VOLUME
TUNING PRESET
TUNER C D SETUP ENTER RETURN
AUX INPUT
VIDEO L AUDIO R
SETUP MIC
DIGITAL INPUT DIMMER MEMORY TUNING MODE
CLEAR

Correcting Sound and Picture Sync

When using progressive scanning on your DVD player,
you may find that the picture and sound are out of sync.
With this setting, you can correct this by delaying the
audio signals. You can set it from 0 to 100 milliseconds
(ms) in 20 millisecond steps.
STANDBY/ON REMOTE MODE

RECEIVER

TAPE/AMP
INPUT SELECTOR
INPUT 1 2
V CR/DVR CBL/SAT
SELECTOR
4 5
AUX MULTI CH DVD
7 8
TAPE TUNER C D
10 11
+ 10 0
CLR
D TUN ENT
--/--- DIMMER SLEEP
CH
TV VOL
DISC
ALBUM
INPUT
GUIDE
TOP MENU
SP A / B
ENTER
PLAYLIST/CAT
SETUP
1 Press the [RECEIVER] REMOTE
MODE button.
RECEIVER
2 Press and hold, for more than 4
seconds, the input selector but-
1 2
ton for the input source that you
VCR/DVR CBL/SAT
want to correct.
4 6
AUX DVD
This can be the [DVD], [VCR/DVR],
[CBL/SAT], or [AUX] input source.
3
Use the Left and Right [
buttons to adjust the delay from 0
to 100 milliseconds in 20 milli-
second steps.
Note:
• This setting is not available when the Pure Audio lis-
tening mode is used, or the Direct listening mode is
used with an analog input signal.
RECEIVER
DVD
M D/CDR
C D
3
DOCK
TV
6
9 VCR
CABLE
12
SAT
VOL
PREVIOUS
MENU
MUTING
PLAYLIST/CAT
RETURN
]/[ ]
61