Table of Contents
Advertisement
GSX-86: Graphics for the
APe
9-30
Output
PRINT GRAPHIC CHARACTERS
for graphics on printer (Diablo, Epson,
and so on)
contr1(2)
-- Number of points
=
I
contr1(4)
-- Number of characters to
contr1(6)
intin
ptsin(l)
ptsin(2)
contr1(3)
-- 0
output
-- 5
-- Graphic characters to output
-- X-coordinate of start point
of characters
-- Y -coordinate of start point
of characters
SET CHARACTER HEIGHT
This operation sets the current text character height in Device Units. The specified
height is the height of the character itself rather than the character cell. The driver
returns the size of both the character and character cell selected. This is a best fit
match to the requested character size.
Input
Output
contr1(l)
contr1(2)
ptsin(l)
ptsin(2)
contr1(3)
ptsout(l)
ptsout(2)
ptsout(3)
ptsout(4)
Opcode
=
12
Number of vertices
=
1
o
Requested character height in device units
(rasters, plotter steps)
Number of vertices
=
2
Actual character width selected in device
units
Actual character height selected in device
units
Character cell width in device units
Character cell height in device units
Advertisement
Table of Contents
