Table of Contents
Advertisement
CP/ M-86 Error Messages
BDOS err on d: bad sector
BDOS err on d: RO
Cannot close
Command name?
G-2
This could indicate a hardware problem or a worn or
improperly formatted disk. Press CTRL-C to terminate
the program and return to
CP/M-86,
or press the enter
key to ignore the error.
BDOS err on d: select
CP/M-86
has received a request specifying a nonexistent
drive, or a disk in a drive is improperly formatted.
CP/M-
86 terminates the current program as soon as you press
any key.
Drive has been assigned Read-Only status with a STAT
command, or the disk in the drive has been changed
without being initialized with a CTRL-C.
CP/M-86
ter-
minates the current program as soon as you press any
key.
ASM-86. An output file cannot be closed. This is a fatal
error that terminates ASM-86 execution. The user should
take appropriate action after checking to see if the correct
disk is in the drive and that the disk is not write protected.
DDT -86. The disk file written by a W command cannot
be closed. This is a fatal error that terminates DDT-86
execution. The user should take appropriate action after
checking to see if the correct disk is in the drive and that
the disk is not write protected.
If
CP/M-86
cannot find the command you specified, it
returns the command name you entered followed by a
question mark. Check that you have typed the command
name correctly, or that the command you requested
exists as a CMD file on the default or specified disk.
Advertisement
Table of Contents
