Transfer And Separation Section - Kyocera Mita KM-4230 Service Manual

2A3/4

3-3-7 Transfer and separation section

( 1 ) Replacing the charger wires and cleaning pads
Take the following steps when the charger wire is broken or is to be replaced, or when
replacing the cleaning pads.
<Precautions>
• Use only the specified tungsten wire for the charger wire.
• The part of the wire wrapped around the charger spring must not protrude from the
rear of the transfer charger housing.
• The cut end of the charger wire must not protrude from under the charger wire
retainer pin.
• Keep the charger wire taut by stretching the charger spring.
• Clean the charger shield when replacing the charger wire.
<Procedure>
1. Turn the paper transfer section release lever to the right to lower the paper
conveying section.
2. Remove the connector, pin and then the transfer charger assembly.
Connector
Figure 3-3-66 Detaching the transfer charger assembly
3-3-56
Transfer charger assembly
Paper transfer section
release lever
Pin
*Illustration shows a 42 ppm.