Setting Up The Audio Options - Samsung DVD-VR350 Instruction Manual

DVD-Recorder
No Disc
Programme
Digital Output
DTS
Setup
Dynamic Compression : On
NICAM
MOVE OK
DVD-Recorder
No Disc
Programme
Digital Output
DTS
Setup
Dynamic Compression : On
NICAM
MOVE OK
DVD-Recorder
No Disc
Programme
Digital Output
DTS
Setup
Dynamic Compression : On
NICAM
MOVE OK
DVD-Recorder
No Disc
Programme
Digital Output
DTS
Setup
Dynamic Compression : On
NICAM
MOVE OK
Downloaded From Disc-Player.com Samsung Manuals

Setting Up the Audio Options

Allows you to setup the audio device and sound status settings
depending on the audio system in use.
You can also adjust the NICAM mode.
1. With the unit in Stop mode/No Disc mode, press the MENU button.
2. Press the ▲▼ buttons to select Setup, then press the OK or ► button.
3. Press the ▲▼ buttons to select Audio, then press the OK or ► button.
Audio setup menu will be displayed.
4. Press the ▲▼ buttons to select the desired audio option, then press
the OK or ► button.
5. Press the ▲▼ buttons to select the desired item, then press the OK or
► button.
▌ Digital Output
Audio
• PCM : Converts to PCM (2CH) 48kHz audio. Select PCM when using
: PCM
►
: Off
►
►
• Bitstream : Converts to Dolby Digital Bitstream. Select Bitstream when
: On
►
RETURN EXIT
▌ DTS
Audio
• Off : Doesn't output digital signal.
: PCM
►
: Off
►
• On : Outputs DTS Bitstream via digital output only. Select DTS when
►
: On
►
RETURN EXIT
▌ Dynamic Compression
Audio
This is only active when a Dolby Digital signal is detected.
: PCM
►
: Off
►
• On : When Movie soundtracks are played at low volume or from smaller
►
: On
►
RETURN EXIT
• Off : You can enjoy the movie with the standard Dynamic Range.
▌ NICAM
Audio
NICAM programmes are divided into 3 types.
: PCM
►
: Off
►
NICAM Stereo, NICAM Mono and Bilingual (transmission in another
►
language).
: On
►
NICAM programmes are always accompanied by astandard mono
sound broadcast and you can select the desired sound.
RETURN EXIT
• On : NICAM mode
• Off : Only set at this position to record the standard mono sound during
the Analog Audio Outputs.
using the Digital Audio Output.
■ Be sure to select the correct Digital Output or no audio will be heard.
connecting to a DTS Decoder.
■ When DTS soundtrack is played, sound is not output from Analog
Audio Output.
speakers, the system can apply appropriate compression to make
low-level content more intelligible and prevent dramatic passages
from getting too loud.
a NICAM broadcast if the stereo sound is distorted due to inferior
reception conditions.
English - 25