Menu1 Adjustment (Effective For Both Analog And Digital Input) - Mitsubishi VS-SH10U Setup And Installation Manual

3.5.3. MENU1 adjustment (effective for both analog and digital input)

The adjustment display will be displayed by pressing
activate the normal mode. If any value is changed in MENU1, the value will be saved in the
memory number displayed at the top of MENU1 (The value will be saved in MEMORY1 if the
display is shown below).
3.5.3.1. DITHER adjustment
Turning ON/OFF DITHER. Normally keep it ON.
[Adjustment]
1) Select DITHER in MENU1.
2) Select ON or OFF.
3.5.3.2. BRIGHTNESS adjustment
Normally unnecessary to adjust the brightness. You can adjust the brightness of darker part of
the picture. However, darkening the picture excessively deteriorates the tone characteristics of
the darker part of the picture. Press
before shipping from factory.
[Adjustment]
1. Select BRIGHTNESS in MENU1.
2. Change the adjustment value.
3.5.3.3. CONTRAST adjustment
Normally unnecessary to change the contrast. You can adjust the picture darkness and
brightness with this adjustment. However, darkening the picture excessively deteriorates the
tone characteristics. Press
shipping from factory.
[Adjustment]
1. Select CONTRAST in MENU1.
2. Change the adjustment value.
3.5.3.4. APERTURE setting
This is use for edge enhancement. Normal setting is OFF.
3.5.3.5. NR setting
This is use to reduce subtle noise in analog signal etc. Normal setting is OFF.
VS-SH10U Set-up and Installation Manual
MEMORY 1
BRIGHT
CONTRAST
WHITE BALANCE
GAMMA
DITHER
CSC
APERTURE
NR
MENU1 adjustment display
NO RMAL NO RMAL NO RMAL NO RMAL
button to reset the value to the value adjusted
NO RMAL NO RMAL
NO RMAL NO RMAL
button to reset the value to the value adjusted before
39
M ENU1 M ENU1 M ENU1 M ENU1
button. Press
ESC ESC ESC ESC
button to