Noise Reduction - Sanyo PLC-XM100 Owner's Manual

Video Input
Offset(Red/Green/Blue)
Press the Point ◄ button to lighten red/green/blue tone of the
black level of an image; press the Point ► button to deepen red/
green/blue tone of the black level of an image (from 0 to 63).
Sharpness
Press the Point ◄ button to decrease the sharpness of the image;
press the Point ► button to increase the sharpness of the image
(from 0 to 31).
Gamma
Use the Point ◄► buttons to adjust the gamma value to obtain a
better balance of contrast (from 0 to 15).

Noise reduction

Noise interference on the screen can be reduced. Press the Point
◄► buttons to change the noise reduction mode.
Off ........... Noise reduction mode is Off.
On ........... Noise reduction mode is On.
Progressive
An interlaced video signal can be displayed in progressive mode.
Press the Point ◄► buttons to change the progressive scan mode.
Off ........... Progressive scan mode is Off.
On ........... Progressive scan mode is On .
Film ......... For watching a film. With this function, the projector
reproduces pictures faithful to the original film quality.
Reset
To reset the adjusted data, select Reset and press the SELECT
button. A confirmation box appears and then select yes. All
adjustments will return to their previous figures.
Store
To store the adjusted data, select Store and press the Point ► or
the SELECT button. Use the Point ▲▼ buttons to select one from
Images 1 to 10 and press the SELECT button.
A confirmation box appears and then select yes. Stored data can
be called up by selecting an Image (1-10) in the Image Mode
Selection on page 46.
Note:
• Noise reduction and Progressive cannot be selected when
480p, 575p or 720p is selected (p.45).
• Noise reduction cannot be selected when 1080p is selected
(p.45).
4
Downloaded From projector-manual.com Sanyo Manuals
Store
Image 1
Image 2
Image 3
Image 4
Image 5
Image 6
Image 7
Image 8
Image 9
Image 10
A confirmation box
appears and then
select yes.
Where to store?