Remote Control Code; Adjustable Feet - Sanyo PLC-XM100 Owner's Manual

Multimedia projector

Hide thumbs Also See for PLC-XM100:

Owner's manual (149 pages)

Network manual (60 pages)

Specifications (1 page)

Table Of Contents

Table of Contents

Part Names and Functions

The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote control

codes prevents interference from other remote controls when several projectors or video equipment next to each other are

operated at the same time. Change the remote control code for the projector first before changing that for the remote control.

See "Remote control" in the Setting Menu on page 56.

Press and hold the MENU and a number button (1–8) for

more than five seconds to switch between the codes.

To initialize the remote control code, slide the RESET/ ON/

ALL-OFF switch to "RESET", and then to "ON". The initial

code is set to Code 1.

Projection angle can be adjusted up to 4.0 degrees with the

adjustable feet.

Rotate the adjustable feet and tilt the projector to the proper height;

to raise the projector, rotate the both feet clockwise.

To lower the projector or to retract the adjustable feet, rotate the

both feet counterclockwise.

To correct keystone distortion, press the KEYSTONE button on the

remote control or select Keystone from the menu (see pages 14,

31, 44, 50).

Downloaded From projector-manual.com Sanyo Manuals