Remote Control Code - Sanyo PLC-XT35 Owner's Manual

Remote Control Code
The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote
control codes prevents interference from other remote controls when several projectors or video equipment
next to each other are operated at the same time. Change the remote control code for the projector first before
changing that for the remote control. See "Remote control" in the Setting Menu on page 52.
1
Press and hold the MENU and a number button (1–8)
for more than five seconds to switch between the
codes.
2
To initialize the remote control code, slide the RESET/
ON/ALL -OFF switch to "RESET, " and then to "ON. " The
initial code is set to Code 1.
Part Names and Functions
Press and hold the MENU and a number button
(1–8) that corresponds to the remote control code
for more than five seconds to switch between
the codes.
MENU button
Number buttons
RESET/ON/ALL OFF
Switch
17