Invacare Force-2 User Manual page 76

®
Top End Force™
Wheel Tray Bracket
Remove the four mounting bolts and locknuts A securing the
1.
wheel tray bracket B to the wheel tray C.
Position the wheel tray bracket B in the desired position.
2.
3. Secure the wheel tray bracket B to the wheel tray C with the
four mounting bolts and locknuts A.
4. If necessary, the wheel stop D may be adjusted to one of three
positions to sit against the front wheel. To adjust the wheel stop
D, perform the following steps:
Remove the mounting bolt and locknut A securing the
a.
wheel stop D to the wheel tray bracket B.
Position the wheel stop D in the desired mounting position.
b.
Secure the wheel stop D to the wheel tray bracket B with
c.
the mounting bolt and locknut A.
Rear Wheel Bar Brackets
To properly secure the handcycle, the rear wheel bar
brackets should be adjusted to sit against the rear wheels.
Loosen the two screws E securing the rear wheel bar bracket
1.
F to the rear wheel bar G.
Adjust the rear wheel bar bracket F in/out until they sit against
2.
the rear wheel.
Secure the rear wheel bar bracket F to the rear wheel bar G
3.
with the two screws E.
4. Repeat steps 1-3 for the opposite side if necessary.
76
Rear Wheel Bar
To properly secure the handcycle, the rear wheel bar should
be adjusted so the rear wheels sit in the rear wheel bar
brackets.
Remove the two mounting bolts and locknuts H securing the
1.
rear wheel bar G to the wheel tray C.
Position the rear wheel bar G to one of three mounting
2.
positions on the wheel tray C.
Secure the rear wheel bar G to the wheel tray C with the two
3.
mounting bolts and locknuts H.
1171790-B