Service Procedures; Installing Rear Wheels With Threaded Axles; Replacing Tire/Tube And Tuning/Replacement Of Spokes; Replacing Camber Inserts - Invacare Force-2 User Manual

6 Service Procedures

6.1 Installing Rear Wheels with Threaded Axles

WARNING!
– After any adjustments, repair or service and before
use, make sure all attaching hardware is tightened
securely. Otherwise injury or damage may occur.
WARNING!
– DO NOT use the handcycle unless it has the proper
tire pressure (p.s.i.). DO NOT overinflate the tires.
Failure to follow these suggestions may cause the tire
to explode and cause bodily harm. tire p.s.i. is printed
on the tire wall.
1171790-B
1. Apply a small amount of grease onto the axles A.
2. Insert the axle A into the axle mounting hole B on the handcycle
frame C. Repeat for other wheel.
Securely each wheel to the frame C with the 6mm wrench D.
3.
There should be no play or threads visible.
6.2 Replacing Tire/Tube and Tuning/Replacement
of Spokes
Invacare recommends that these procedures be performed
by a qualified technician.

6.3 Replacing Camber Inserts

Loosen, but do not remove the socket screws A and clamps B
1.
that secure the camber inserts C to the camber bar D.
Remove the existing camber insert C from the camber bar D.
2.
Install the new camber insert C into the camber bar D.
3.
4. Adjust the toe in/toe out of the handcycle. Refer to 5.7 Adjusting
Toe In/Toe Out, page 50 .
Service Procedures
55