Related Manuals for Blanco BIC603S
Summary of Contents for Blanco BIC603S
- Page 1 Instructions for the Use and Care and Installation of BIC603S BIC604S BIC75S Induction Cooktop...
- Page 2 It is easy to use and performs to a high standard. Blanco also makes a range of products that will enhance your kitchen – such as cooktops, ovens, dishwashers, microwaves, sinks and taps. There are models to complement your new Blanco rangehood.
- Page 3 Fig.1 - Glass-ceramic cooker top. - Pan with ferromagnetic base. - Magnetic field. - Archimedean spiral coil. - Current. - Electric circuit. - 3 -...
- Page 4 Fig.2 Fig.2B 220-240V 1N ~ H05V2V2-F 3G 220-240V 2~ H05V2V2-F 3G 380-415V 2N~ H05V2V2-F 4G - 4 -...
- Page 5 Fig.3 - 5 -...
- Page 6 Fig.4 5 8 0 - 7 7 + 2 0 M i n 5 6 0 - 7 5 M i n Fig.5 - 6 -...
- Page 7 - 40 % Fig.6 Fig.7 50 mm 4 mm 25 mm 80 mm 500 x 10 Fig.8 - 7 -...
- Page 8 50 mm 4 mm 40 mm 500 x 10 500 x 50 Fig.9 - 8 -...
-
Page 9: Safety Warnings
SAFETY WARNINGS • Read the following carefully to avoid an electric shock or fire. • It is most important that this instruction book should be retained with the appliance for future reference. • Should the appliance be sold or transferred, always ensure that the book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings. -
Page 10: Other Information
Caution: if you are using a pan with a diameter which is more than 40% smaller than the printing marked on the glass, the cooking zone may not be activated. 1.3 Cooking vessels (Fig.6A): Cooking by induction uses magnetism to generate heat. The vessels must therefore contain iron. Check if the vessel material is magnetic using a magnet. -
Page 11: Use And Maintenance
Important: if there is an oven under the induction hob it is advisable for it to have a cooling fan. Do not use the induction hob while PYROLITIC cleaning is in process. Warning: to allow the circulation of as much fresh air as necessary, there must be at least 40 mm between the induction hob module and any appliance installed under it (Fig.9B). - Page 12 above approximately 50°, the display (R) corresponding to that zone will show a luminous signal alternating between “0” and “H”. - If the hob is switched to the OFF setting (A), the luminous signal will display the letter “H” in a fixed manner. Warning: To prevent damage being inflicted on the electronic circuits, the hob is fitted with an overheating safety system.
- Page 13 To deactivate the timer function before the set time: - Select the cooking zone (E) and press one of the two buttons (N). When the zone indicator (R) on display (E) stops flashing, the function is no longer active. Note: to display the residual cooking time, just press the cooking zone (E) of interest selection button. • Minute Minder (Countdown): Attention! This function can only be used if no cooking zone (E) has the Timer inserted.
- Page 14 the memory. The hob can remain in this situation for maximum 10 minutes. Then, the hob will switch off permanently. Activation: - Select key “Pause” (B) and the relative LED (C) will start flashing. The symbol will be displayed. Restore of the cooking phase: 1.
- Page 15 • Error codes: Error code: Description: Possible causes: Error recovery: The cooking zone can be config- It’s not an error, the user is in the A suitably pan must be placed on the ured if a static “C” is shown. service menu.
- Page 20 Printed on recycled paper 3LIP0360...