Page 1
Lang Manufacturing Main Numbers: 6500 Merrill Creek Parkway 425.349.2400 Everett WA 98203 800.882.6368 www.langworld.com Fax: 425.349.2733 URPLE ONVECTION VENS EHS-C, ECCO-C, GCCO-C UICK ROGRAMMING UIDE ERSION 5, 2006 PRIL Purple Programming.doc...
Page 2
URPLE ROGRAMMING EHS-C, ECCO-C, and GCCO-C ONTROL ANEL UTTON EFINITIONS 1 -0 B Product Buttons. These are the buttons where the product programs are stored. UTTONS Pressing a Product Button will heat the oven to the programmed temperature. A – E B Shelf Buttons.
Page 3
URPLE ROGRAMMING EHS-C, ECCO-C, and GCCO-C PERATING ODES Below are codes, which will allow you to configure the display or aid in the operation, and troubleshooting of the oven. The readout must display "enter " before the computer will accept any programming code. If the readout displays any other word, reset the computer by pressing and holding the “R/C”...
Page 4
URPLE ROGRAMMING EHS-C, ECCO-C, and GCCO-C ROGRAMMING NSTRUCTIONS ACTION DISPLAY Turn the power switch on. If the oven is already on, turn it off and then back enter Quickly enter access code “R/C, 1, 6, 2, 7, 3, 8”. Do not hold the R/C prod button.