Program Menus - Curtis TCT Service Manual

Programming
Your Curtis Generation 3 Brewer is Factory Pre-Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
CURTIS
The control displays
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached
screen. It takes approximately 20 minutes to reach set point temperature of 204°F.
CURTIS
Control will display
READY to BREW
To Go Into Programming
Turn off (dark display) by pressing ON/OFF button (yellow). Press and hold BREW button 4 (green) and then press and release ON/OFF button (yellow).
Continue holding BREW button. Display will read
spond to the buttons (see illustration below).
The default code set at the factory is 1-2-3-4. Then
1 2 3
SPRAYHEADS: Mentioned in this Programming guide are the words Gray and Purple. This refers to the color of the sprayhead. The current
sprayhead is the purple AFS. The older version is the gray sprayhead. See the illustration at right.

Program Menus

Program Menus
Program Menus screen. Press > button, to show the next menu item.
Recipes (Factory set to Standard Tea Purple)
Press  to Select. Press < or > to scroll through recipes: Standard Gray, Standard Purple, Tropical Gray, Tropical
Recipes
Purple, 76/308 Gray or 76/308 Purple. Press  to set.
Tea by Volume: Press  to select, Display will now show Push START To Begin... Press the BREW button then
*
hot water starts running, when desired volume is reached press BREW button again to stop the flow. Now the
Tea By Volume
volume has been set. Pressing > button will display the subsequent menu features.
Tea by Time (Factory set to 5:52)
*
Tea By Time
Press  to select. By pressing < or > buttons, you can increase and decrease time. Press  to set minutes and
seconds. Units with the half batch option, the Half Batch brew button is factory set at for half the brew time (2:56).
* Tea Dilution Delay (Factory set to 0:30)
Tea Dilut Delay
Press  to Select. Press < or > buttons, to add or decrease time. Press  to set.
Tea Dilution Volume: Press  to Select, Display will now show Push START To Begin... Press the BREW button
*
and water will flow, when desired volume is reached press BREW button again to stop the flow. Now the volume
Tea Dilut Volume
has been set. Press > to display subsequent menu features.
Dilution Time (Factory set to 4:05)
*
Tea Dilut Time
Press  to Select. By pressing < or > buttons, you can increase and decrease time. Press  to set minutes and
seconds.
*
2
. Press ON/OFF button and the screen will display
when temperature reaches the set point (204°F). Unit is now ready to brew.
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
4
On units with the half batch option, the half batch brew button may be independently set.
< TCT >
CURTIS
, wait until is displayed Enter the 4-digit access code, the digits 1-4 corre-
will be displayed.
Scroll LEFT
 SELECTION or ENTER to save new parameter
Scroll RIGHT
CURTIS
. After three seconds,
FILLING
CURTIS
will appear on the
HEATING
is displayed.
GRAY
PURPLE
Continued on Page 3