Clevo W760SUA Service Manual page 37

Processor Installation Procedure
1. Insert the CPU , pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE IT!), and
A
turn the release latch towards the lock symbol
B
2. Remove the sticker (Figure
C
3. Insert the heat sink as indicated in
D
4. Tighten the CPU heat sink screws in the order
5. Replace the component bay cover and tighten the screws
a.
A
b.
(Figure
9c) from the heat sink.
Figure 9c.
, , , &
1 2 3
(page 2 -
c.
d.
3
1
B
9b).
(the order as indicated on the label).
4
9).
C
D
2
4
Removing and Installing the Processor 2 - 13
Disassembly
Figure 9
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
wards the lock symbol.
c. Remove the sticker from
the heat sink and insert
the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
• 4 Screws