Color Plate Conversion - Russound MDK-C5 User And Installation Manual

MDK-C5 Color Plate Conversion
You will need both small straight and Phillips head
screwdrivers to change the color plates on the keypad. The
Bezel Molding and the Trim Plate will be switched for the
new color plates.
1. If installed, remove the MDK-C5 keypad from the
wall. Gently pull the Trim Plate off the mounting
plate. Unscrew the unit from the electrical box, and
disconnect the cable.
2. Unscrew the plastic Frame Plate. Keep the Frame Plate
and screws for reattachment later.
3. Remove the Display Lens from the Bezel Molding by
providing inward pressure to the two locking tabs
while simultaneously pushing it away from the Bezel
Molding.
4. Once the Display Lens is removed, put aside for
reattachment later. Be careful to not damage the
display.
HOME
VOL
MENU
VOL
Metal Frame Display Lens
Bezel Molding
Keypad Disassembly / Assembly
Russound MDK-C5 User and Installation Manual
KEYpAD COLOR pLATE CONVERSION
5. Remove the Bezel Molding by gently pressing in each
of the 4 locking tabs (2 per side) while pushing it away
from the metal frame.
6. Reverse the order for installation, taking the following
precautions:
a. Make sure the button key mat is positioned properly
on the front circuit board and without dust or debris
on the button contact points prior to attaching the
Bezel Molding.
b. Make sure that there isn't any debris or fingerprints
on either the display or back of the Display Lens prior
to reattachment.
c. Use a clean, dry, lint-free soft cloth to gently wipe
the display or back of the Display Lens to clean if
necessary. Never use cleaning agents as this can cause
streaking or permanent damage to either part.
Screws
Screws
Frame Plate Trim Plate
9