Color Conversion - Russound MDK-C6 Installation Manual

MDK-C6 Color Plate Conversion
You will need both small straight and Phillips head
screwdrivers to change the color plates on the keypad. The
Bezel Molding, Buttons and the Trim Plate will be switched
for the new color plates.
1. If installed, remove the MDK-C6 keypad from the wall.
Gently pull the Trim Plate off the mounting plate. Unscrew
the unit from the electrical box, and disconnect the cable.
2. Unscrew the plastic Frame Plate. Keep the Frame Plate
and screws for reattachment later.
3. Remove the Bezel Molding by gently pressing in each of
the 4 locking tabs (2 per side) while pushing it away from
the metal frame. CAUTION: To avoid damage to the LCD
panel, do not use hard edged tools.
4. Remove the Display Lens from the Bezel Molding by
gently pushing from the rear to overcome the clips.
5. Once the Display Lens is removed, put aside for
reattachment later. Be careful to not damage the display.
Locking
Tabs
Buttons
Metal Frame Bezel Molding
Keypad Disassembly / Assembly
Key Mat
Display Lens
Frame Plate
Russound MDK-C6 User and Installation Manual
KEYPAD COLOR CONVERSION
6. Remove individual button caps by pulling them off the
key mat.
7. Reverse the order for installation, taking the following
precautions:
a. Place button caps correctly on the key mat. Make sure
the key mat is positioned properly on the circuit board
and without dust or debris on the button contact points
prior to attaching the Bezel Molding.
b. Make sure that there isn't any debris or fi ngerprints
on either the display or back of the Display Lens prior to
reattachment.
c. Use a clean, dry, lint-free soft cloth to gently wipe the
display or back of the Display Lens to clean if necessary.
Never use cleaning agents as this can cause streaking or
permanent damage to either part.
Trim Plate
Screw
Note:
Place individual buttons on key
mat matching the diagram below.
Key Mat
Individual Buttons
9