Upgrading The Printer Software - For Windows - Kodak ESP 7 User Manual

Upgrading the printer software - for Windows

You can upgrade the software and firmware for in your printer with the most recent
release available. This requires an Internet connection.
NOTE: The firmware cannot be upgraded when your printer is connected via a
network or Wi-Fi. Your printer must be connected to the computer with a
USB cable in order to perform a firmware upgrade.
1. If your connection is via Ethernet, disconnect the Ethernet cable. If your
connection is via Wi-Fi, press Menu . Navigate to Network Settings menu and
press OK . Select WIFI Radio off .
2. Connect the printer to the computer with a USB cable. The computer must be
connected to the internet.
A pop-up window appears at the bottom right corner of your computer monitor
stating "Found New Hardware KODAK ESP 7 AIO," then changes to "Found New
Hardware. Your new hardware is installed and ready to use."
3. Open the Kodak AiO HomeCenter.
4. Click the Help button to open the Help Panel.
5. Under the General Links, click Maintenance . If there is an update available, you
will receive a pop-up window or you can click on Firmware Upgrade .
6. Click OK to upgrade. The printer software will begin to load. Do not turn off your
printer while the update is in progress.
7. When the update is complete, click OK .
8. Close the maintenance window. The printer firmware is updated.
9. Next you will update the Home Center software, as well as the printer and
scanner drivers.
10. Under the Web Links on the Help Panel, click on Check for updates .
11. If an update is available, download it to your computer.
12. When the update is complete, disconnect the USB cable and reconnect your
printer to the Ethernet or Wi-Fi network.
13. Use the Windows Control Panel to delete the printer from your computer. The
USB printer is named Kodak ESP7 AiO. This will remove the USB drivers.
www.kodak.com/go/aiosupport
KODAK ESP 7 All-in-One Printer
65