Status Lights - Kodak ESP 7 User Manual

Printer Overview

Status lights

Light Status
Off The printer is turned off.
The printer does not have
power applied.
Blinks The printer is initializing or
busy.
On The printer is ready.
Light Status
Off The printer power cord is not
properly connected to the printer.
The electrical power cord is not
properly connected to your
electrical outlet.
The electrical outlet has no power.
The problem may lie with the power
supply.
On The power supply is supplying
power to the printer.
14
The tables below describe the meaning of each light and condition, and offer tips on
what action to take.
Cause
a
Most power supplies used with this printer are equipped with a status light which illuminates
when electricity is applied. If you cannot determine if the power supply is working properly, contact
Kodak Service & Support for assistance.
Printer Power Cord Light
Cause
www.kodak.com/go/aiosupport
On/Off Lights
Action/Solution
Press On/Off to turn the printer on.
Ensure that the printer power cord is properly plugged into
the back of the printer.
Verify that the power supply and/or power cord LED is lit.
Check that the power supply is connected to the power
cord, and that it is properly connected to the electrical
a
outlet.
None. Allow the printer to finish the initialization process.
None.
Reconnect the printer power cord plug to the printer.
Reconnect the cord to the electrical outlet. Ensure
that the electrical power cord is fully connected to
the alternating current (AC) adapter at the end of
the printer power cord.
Plug a working device into the wall outlet to test it,
or have it checked by an electrician.
Check the power supply status light, if available. As
needed, visit Kodak.com for additional
troubleshooting steps, or contact Kodak Service &
Support.
None.
Action/Solution