Error Codes - Salter Brecknell PR-3000 Series Operation Manual

APPENDIX C: DISPLAYED
CODE MODE
Normal Operating
Mode
Err 0 Span Calibration
Mode (F17)
Err 1 Span Calibration
Mode (F17)
Err 2 Span Calibration
Mode (F17)
Err 3 All Modes
Err 4 All Modes
Err 7 Initialization
Normal Operating
Err 9
Mode
Err 10 Initialization or Setting
Code Entry
Err 11 Initialization
Err 12 Initialization or Setting
Code Entry
Setting Code Entry
Err 13
Note: Contact Service Department at Transcell for instructions on how to re-enter setting code.

ERROR CODES

Gross Overload. A weight greater than the rated capacity has been
applied to the scale. Remove the weight from the platter or try re-
calibrating the scale. Otherwise, check for a bad load cell connection or
possible load cell damage due to overloading.
Keyed-in weight value is less than 1% of full-scale capacity. Use a larger
test weight or check keyed-in value.
Keyed-in weight value is larger than full-scale capacity. Use a smaller test
weight or check keyed-in value.
There is not enough load cell signal to produce the internal counts
necessary to properly calibrate the scale. First check all load
connections. Use F16 mode to view internal counts. See Appendix C for
more information.
Non-volatile memory read error. One or more setup parameters have
been lost.
Non-volatile memory write error. Indicator needs service.
No reading from the ADC. Could indicate a damaged load cell.
Span calibration value has been lost. Re-calibrate the scale.
Indicator cannot read serial number. Indicator must be returned for
service.
Serial number mismatch. Re-enter setting code from product ID tag.
Invalid setting code. Re-enter proper setting code from product ID tag.
Non-volatile memory is in write-protect mode. Toggle position of
Setup/Calibration Switch (See Chapter 5).
19
MEANING / POSSIBLE SOLUTION