Maintenance And Cleaning; Led Light System - Whirlpool Refrigerator Instructions For Use Manual

MAINTENANCE AND CLEANING

Before any cleaning or maintenance operation,
unplug the appliance from the mains or disconnect
the electrical power supply.
Periodically clean the appliance with a cloth and a
solution of lukewarm water and neutral detergent
specifically for refrigerator interiors.
Never use detergents or abrasives.
Never clean refrigerator parts with flammable
fluids.
The fumes can create a fire hazard or explosion.
Clean the outside of the appliance and the door
seal with a damp cloth and dry with a soft cloth.
Do not use steam cleaners.
Clean the condenser using a vacuum cleaner,
proceeding as follows: remove the front plinth and
proceed to clean the condenser.
Important:
• The buttons and control panel display must
not be cleaned with alcohol or alcohol-derived
substances, but with a dry cloth.
• The refrigeration system pipes are located
near the defrost pan and can become hot.
Periodically clean them with a vacuum cleaner.
• To remove or insert the glass shelf move up the
front part of the shelf to pass the stopper.
To ensure continuous and correct flow of defrost
water, regularly clean the inside of the draining
hole on the back of the refrigerator near the fruit
and vegetable drawer, using the tool provided .

LED LIGHT SYSTEM

The light system inside the refrigerator
compartment uses LEDs light, allowing a better
lightning as well as very low energy consumption.
If the LED light system does not work, please
contact the Service to replace it.
Important: The refrigerator compartment light
switches on when the refrigerator door is opened.
If the door is kept open for more then 10 minutes
the light will be automatically switched off.
11