STEP 1: Set Up Your Device
The AT&T Home Base uses the AT&T cellular network and DOES NOT
use your home phone wall jacks.
Your device should be located:
•
Where you have a
strong signal from a
cell tower, typically
near a window
or outside wall.
Signal strength may
vary in different parts
of your home.
•
Near an electrical wall outlet.
•
In the general area where you'll be using your home phone,
computer, or Wi-Fi enabled devices.
Install the Back-up Battery
A
1.
Remove the bottom of the device by pushing the entire
cover in the direction of the arrow.
2.
Insert the back-up battery.
3.
Replace the cover.
Turn on Your Device
B
1.
Plug the power cord into an electrical wall outlet.
2.
Connect the other end of the power cord into the Power
Input port on the back of your AT&T Home Base.
3.
Press and hold down the round On/Off button for 3 full
seconds until the power light stays steady green.
C
Check the Wireless Signal
while your device connects to the cellular network.
Confirm signal strength light is green for optimal performance.
Yellow indicates a moderate signal and may be sufficient.
NOTE:
If you do not see a green light, you may want to
choose another location in your home, such as near a
window or outside wall.
On/Off
Hold 3 seconds
Signal
Strength
STEP 2: Connect the Device to a Phone
Unplug Your Phone from the Wall Jack
A
The AT&T Home Base is not used with your home phone
wall jack.
NOTE:
If you have a cordless phone, keep it plugged into a
power outlet.
B
Connect Your Phone to the Device
Plug your phone into the "Phone 1" port on the AT&T
Home Base, using your existing phone cable or the included
phone cable.
NOTE:
Do not plug the device into your home phone
wall jack.
Place a Test Call
C
Place a test call from your connected home phone. Make sure
to dial the 10-digit phone number, including area code.
For best results, place the cordless phone base at least 12
inches from the AT&T Home Base.
Email Setup
(Optional)
To set up a free AT&T email account, go to att.net/signup and select
Start Now.
Set up Voicemail and Additional Phones
•
Voicemail is included with your service. Dial "1" to set up and
access. If using an answering machine, set it to fewer than 5 rings.
•
To place phones throughout your home, use a cordless phone
system with multiple handsets. Wall jacks are not used with the
AT&T Home Base.