Leds; Hardware Interrupt Switch; Connectors And Cables; Console Cables - 3Com SuperStack II 32x Installation Manual

Power
receptacle

LEDs

Hardware
Interrupt Switch
Connectors and
Cables

Console Cables

On/off
switch
RPS
connector
Figure 2-2 Chassis Back Panel
See "LED Meanings" on page 4-3 for a complete description of the
SuperStack II bridge/router LEDs.
The hardware interrupt switch is located on the left side of the
bridge/router (when facing the front panel). It is recessed into an
opening near the DIP switches. Press the switch with a nonconductive
object, such as a plastic stylus to put the system into the monitor
firmware utility.
WARNING: Use only a nonconductive object such as a plastic stylus to
press the hardware interrupt switch. Do not use the tip of a pencil.
Graphite particles from the pencil may cause you to receive an electric
shock and damage components on the motherboard.
This section describes each connector on the bridge/router.
You can connect a PC running a terminal emulation program, a
terminal, or a modem to the Console port on the SuperStack II
bridge/router.
WARNING: To eliminate cable noise emission in excess of FCC Part 15,
Subpart J, and EN55022 B, this device cable should be shielded and
have connectors with metallic backshells.
MODEL: ESPL-310
S/N:
NETBUILDER
1SC05427
REMOTE OFFICE
222 8.3
NTWK
080002 04BA1E LAN
100-240VAC, 50/60HZ, 1.0-0.5A
04BA1F WAN-A
ADDR:
04BA20 WAN-B
250V, F2A
04BA21 WAN-C
FOR CONTINUED PROTECTION
AGAINST FIRE HAZARD
REPLACE FUSE ONY WITH
SAME TYPE AND RATING 07/31/95 20-0261-000
3COM CORP. SANTA CLARA, CA. MADE IN USA
Product
information label
LEDs 2-3