Upgrading Memory; Removing The Cover - 3Com SuperStack II 32x Installation Manual

3
Removing the
Cover
U
PGRADING
The following memory upgrades are available from 3Com for your
bridge/router:
4 MB (3C8104) flash memory
4 MB DRAM (3C8040)
Complete the following sections to install flash memory or DRAM in
your SuperStack II bridge/router.
CAUTION: If you install the flash memory upgrade and then remove it
from your system after startup, you will need to reload the system
software using the procedures described in the software guide.
1 Turn off the power and unplug the power cord from your SuperStack II
bridge/router. Unplug the RPS cable, if connected.
2 Remove the two screws on the back of the bridge/router.
Remove these two screws
3 Slide the cover back and up off the bridge/router.
M
EMORY
MODEL: ESPL-310
S/N:
NETBUILDER
1SC05427
REMOTE OFFICE
327 8.3
NTWK
080002 04BA1E LAN
100-240VAC, 50/60HZ, 1.0-0.5A 04BA1F WAN-A
ADDR:
04BA20 WAN-B
250V, F2A
04BA21 WAN-C
FOR CONTINUED PROTECTION
AGAINST FIRE HAZARD
REPLACE FUSE ONY WITH
SAME TYPE AND RATING 07/31/95 20-0261-000
3COM CORP. SANTA CLARA, CA. MADE IN USA