Installing Memory - 3Com SuperStack II 32x Installation Manual

3-2 C 3: U
HAPTER PGRADING

Installing Memory

M
EMORY
CAUTION: Make sure you do not accidentally alter the dip switch
settings when you remove the cover.
Dip switches should all
be in the down position
To install the flash memory and/or DRAM SIMM, follow these steps:
1 With the chips facing toward the back of the bridge/router, place the
silver connector edge of the SIMM into the appropriate SIMM socket at
almost a 90-degree angle.
2 Align the semicircular notch with the ridge in the SIMM socket.
Do not force the SIMM. It can be installed in only one direction.
3 Once the SIMM is aligned, gently push down on the outer corners of
the SIMM until it snaps into place.
End view
Flash slot
DRAM slot
CAUTION: Before continuing with the next section, be sure that all screws and
pins are properly seated and the dip switches are properly aligned.
1
2