General Operation; Clean Water/Solution Tank; On-Off Switch - Hoover POWER PATH Owner's Manual

3. GENERAL OPERATION

REMOVE AND REPLACE CLEAN
WATER SOLUTION TANK
CAUTION
! !
Do not fill with water above 140°F (60°C).
3.1 Press Clean Water Solution Tank latch (A). Tilt Clean
Water Solution Tank away from cleaner and remove.
3.2 Unscrew measuring cap from the top of Clean Water
Solution Tank (B).
3.3 Fill Clean Water Solution Tank with hot tap water.
3.4 Fill measuring cap with cleaning solution 2 times,
(approximately 2 oz.). Pour into solution tank and replace
measuring cap.
3.5 Insert clean water solution tank on an angle to attach to
unit.
NOTE: Using more than the recommended amount of
cleaning solution may cause excessive foaming.
CAUTION
! !
DO NOT USE THIS EXTRACTOR AND ACCESSORIES ON
HARD FLOORS. USING THIS MACHINE ON HARD FLOORS
MAY SCRATCH OR DAMAGE YOUR FLOOR.
CAUTION
! !
Do not clean over floor electrical outlets.
WARNING
! !
To reduce the risk of fire and electric shock due to internal
®
component damage, use only HOOVER cleaning fluid
intended for use with the appliance.
CARPET CLEANING
3.6 Plug cord into electrical outlet. Step on handle release
pedal, to put unit in cleaning position.
3.7 Turn power switch to the "ON" position.
3.8 Squeeze trigger (C) to apply cleaning solution and slowly
push cleaner forward (equals one wet stroke). Continue to
squeeze trigger and slowly pull cleaner back toward you
(second wet stroke).
3.9 Release trigger and slowly push cleaner forward over
area just sprayed with solution (dry stroke). Then slowly pull
cleaner back toward you without squeezing trigger (dry
stroke). Continue using dry strokes until little water is visible
passing through the nozzle (Pass over the same area a
minimum of 4 times = 2 while squeezing the trigger and 2
without).
NOTE: For best results, use straight, parallel strokes.
Overlap strokes by 1 inch to help prevent streaking.
3.1 3.2
A
3.4
3.3
3.5 3.6
3.8
3.7
C
3.9
CAUTION
!
Detergents contain Anionic
and Nonionic Surfactants.
Avoid contact with eyes and
skin. In case of contact with
eyes, flush with cold water
for 15 minutes. In case of
contact with skin, wash with
water. If irritation persists, call
a physician.
7
B
!